Tous les composants de dalle en beton avec quantites

Estimateur de Composants de Dalle en Beton

D'abord la reponse: entrez les dimensions et specifications de la dalle. Obtenez les estimations de tous les composants.

Pour une dalle 10×10 pi a 4 po

1.36 vc beton + 1.2 vc gravier + treillis

Avec 10% de dechets pour le beton et le gravier.

Outils supplementaires

Malaxeur, lisseuse, niveau, scie

Louez ce que vous n'avez pas pour les projets ponctuels.

Carte des composants première réponse

100 sq ft slab component estimate

For a 100 sq ft slab at 4 inches thick, the concrete anchor is about 1.36 yd3 with 10% waste. The useful estimate then adds base, forms, reinforcement, vapor barrier, joints, tools, delivery, and quote exclusions before you buy.

ComposantQuantité de planificationVérification du devis
Concrete1.36 yd3 / 1.04 m3, or about 62 common 80-lb bagsConfirm waste, bag yield, truck minimum, delivery fee, and short-load terms.
Gravel baseAbout 1.23 yd3 loose base for 4 in depth before compactionAsk whether excavation, haul-off, compaction, drainage, and base repair are included.
FormsAbout 40 linear ft for a 10x10 slab perimeterCheck board height, stakes, form removal, edge detail, and cleanup ownership.
Rebar or meshScope-dependent; use slab rebar takeoff for bar size and spacingRequire bar size, spacing, chairs, laps, mesh or fiber substitution, and inspection timing.
Vapor barrier100 sq ft plus overlap and penetration allowance when neededCheck barrier thickness, seams, puncture repair, and whether the slab use requires it.
Joints and curingSaw-cut/control-joint plan plus curing suppliesConfirm joint spacing, saw-cut timing, finish, curing method, and warranty assumptions.

Interactive workflow

Run the numbers, then save or export the project

View planning notes
Best reviewed quote
Ready-mix supplier A
Red flags
0
Proposal total
$3,824
Pour window
171 min
Liste de courses de materiaux
Resultats des achats

Plan d achat au detail

Compare store delivery and ready-mix before committing to a large bag order.

Ready-mix or store delivery quote
Dry load
11,920 lb
Pallet check
4 pallets
Pickup loads
9 planning loads

80 lb concrete bags

149 bags

Rounded up with waste. Verify product yield on the bag.

Gravel base

3.8 tons

Assumes a compacted base allowance for a small slab.

Form boards and stakes

60 linear ft

Square-project approximation. Measure the actual perimeter.

Rebar or wire mesh allowance

8 pieces / sheets

Confirm reinforcement needs locally before ordering.

Placement and cleanup supplies

1 job kit

Mixer, wheelbarrow, screed, float, edger, curing, PPE, and washout.

Enregistrez cette estimation ou telechargez un rapport PDF

Le rapport PDF utilise le resultat calcule actuel. Enregistrez dabord lestimation lorsque vous souhaitez reutiliser les donnees plus tard.

Beton et gravier
Calculez le beton et le gravier de base pour votre dalle.
Armature
Estimez l'armature ou le treillis necessaire.
Autres composants
Pare-vapeur, coffrage, scellant et outils.

Concrete slab component checklist

Use this table when a volume calculator gives the concrete amount but the actual slab order or bid still needs component-level scope.

Signal to checkWhat it meansNext step
Concrete volumeLength x width x thickness plus waste gives yd3, m3, ft3, and bag count.Confirm product yield, ready-mix minimum, delivery fee, and whether the quote bills usable or minimum yards.
Gravel baseArea x base depth gives base volume before compaction, haul-in, and grading assumptions.Ask whether excavation, compaction, drainage, geotextile, and base repair are included.
Forms and stakesPerimeter drives form boards, stakes, layout time, edge accuracy, and cleanup.Require form height, edge detail, form removal, and who owns correction work in writing.
Rebar, mesh, or fiberReinforcement choice changes material, labor, chairs, laps, inspection timing, and approval responsibility.Use the slab calculator rebar takeoff or ask the contractor to specify bar size, spacing, mesh, fiber, chairs, and substitutions.
Vapor barrier and jointsGarage, shed, basement, and conditioned-space slabs often need moisture and joint decisions before the pour.Check barrier thickness, seams, penetrations, saw-cut timing, curing, finish, and warranty responsibility.
Access and deliveryChute reach, wheelbarrow distance, pump/buggy needs, wait time, and washout can change the delivered total.Run the delivery, pump-vs-wheelbarrow, or quote reviewer workflow when the path from truck to forms is unclear.

Related concrete planning tools

Move from a single calculation into a purchase, proposal, or pour-day decision with connected calculators and checklists.

Quels sont les composants d'une dalle en beton?

Beton, gravier de base (4 pouces), pare-vapeur (dalles interieures), armature et scellant.

Faut-il un pare-vapeur?

Pour les dalles interieures, garages et sous-sols: oui.

Combien d'armature ou de treillis faut-il?

Treillis 6x6 pour dalles residentielles legeres. Armature 1/2 pouce tous les 45 cm pour les entrees.

Combien de scellant faut-il?

Typiquement un contenant de 4 litres couvre 20-28 m2.

Planning disclaimer

Les estimations de composants sont a des fins de planification.