Rebar spacing and slab quote workflow
Rebar Spacing Calculator
Answer first: enter slab length, width, thickness, and a rebar grid spacing to estimate bars each way, linear feet, 20 ft sticks, steel weight, chair count, and material cost. Then keep design approval, laps, dowels, supports, and inspection scope out in the open before you compare bids.
20 x 20 ft slab
31 common 20 ft sticks
At 18 in spacing, 3 in edge clearance, #4 bar, and 10% waste before final laps or cut-list changes.
Differentiation
Takeoff + quote scope
Most calculators stop at bar count. This page also screens chairs, weight, cost, substitutions, and bid wording.
Enter slab size
Concrete volume baseline
Estimation en directListe de verification du devis d espacement des armatures
A calculator result is useful only when the written scope matches the same grid, material, supports, and inspection assumptions.
| Ligne de soumission | Quoi verifier | Pourquoi c est important |
|---|---|---|
| Bar size and spacing | #3, #4, #5, or #6; spacing each direction; one-way or two-way grid. | Changing spacing from 24 in to 12 in can materially change steel, labor, and inspection time. |
| Edge clearance and cover | Distance from form edges and planned vertical position in the slab. | Steel at the wrong location may not match the design or crack-control intent. |
| Laps, dowels, and extras | Overlap length, dowels into existing concrete, edge bars, openings, sleeves, and thickened edges. | These often hide outside a simple grid calculator and can change the final order. |
| Supports and placement | Chairs, bolsters, tie wire, cutting, bending, and who places the steel before the pour. | A material-only rebar count does not mean reinforcement will stay where it belongs. |
| Substitution language | Whether wire mesh, fiber, or no reinforcement is being substituted for rebar. | Different reinforcement scopes should not be compared as if they were the same bid. |
Comment calculer l'espacement des barres d'armature pour une dalle de béton ?
Measure the slab, subtract edge clearance on both sides, divide the usable distance by the planned spacing, then add one bar. Repeat in the other direction for a two-way grid, then multiply by bar length and add lap or waste allowance.
Ce calculateur choisit-il le bon espacement des barres d'armature ?
No. It estimates a material takeoff after spacing is known. The correct spacing, bar size, cover, laps, dowels, and inspection requirements should come from the project drawing, local code, engineer, inspector, or qualified contractor.
How many rebar sticks are needed for a 20x20 slab?
A 20 ft x 20 ft slab with a two-way #4 grid at 18 in spacing and 3 in edge clearance screens at about 601 linear ft after 10% waste, or about 31 common 20 ft sticks before lap, cut-list, and extra edge details are checked.
Should chairs be included in a rebar estimate?
Yes. If reinforcement is specified, the quote should say how the steel or mesh is supported. This page estimates a chair/support count from the slab area and chair spacing so that line is visible in the scope.
Is wire mesh the same as rebar?
No. Rebar, wire mesh, fiber, dowels, and no reinforcement are different scopes. Use this calculator for rebar takeoff, then compare any substitution in writing before approving a contractor bid.